XF86(4) OpenBSD Programmer's Manual XF86(4)NAMExf86 - X Window System aperture driver
SYNOPSIS
option APERTURE
DESCRIPTION
On the alpha, amd64, i386, macppc, and sparc64 architectures, the
/dev/xf86 driver provides access to the memory and I/O ports of a VGA
board and to the PCI configuration registers for use by the X servers
when running with a kernel security level greater than 0.
The X servers require the use of this driver for isa(4) or pci(4) video
cards on alpha, amd64, i386, macppc, and sparc64.
ACCESS CONTROL
Access to the /dev/xf86 device is allowed when the sysctl(8) variable
machdep.allowaperture is greater than or equal to 1. This variable
(which has a default value of 0) can only be raised when the security
level is less than or equal to 0, so it should be set in
/etc/sysctl.conf. The possible values for machdep.allowaperture are:
0 the aperture driver is disabled. Opening it returns EPERM.
1 the aperture driver allows access to standard VGA framebuffer and
BIOS. Access to pci(4) configuration registers is also allowed.
2 in addition to allowing access to pci(4) configuration registers,
the aperture driver allows access to the whole first megabyte of
physical memory, permitting use of the int10 emulation in X.Org
6.8 and later. Note that this can cause some security problems,
since the process that has access to the aperture driver can also
access part of the kernel memory. This mode is not supported on
alpha or sparc64.
SEE ALSOXorg(1), options(4), pci(4), sysctl.conf(5), securelevel(7), config(8),
sysctl(8)HISTORY
/dev/xf86 was integrated as an in-kernel device on OpenBSD 2.3. It is
required in order to allow access to I/O ports for all X servers since
OpenBSD 2.4.
AUTHORS
The aperture driver was written by Matthieu Herrb.
BUGS
This driver allows access to all addresses above physmem. It should be
restricted to the actual address range of the video memory.
OpenBSD 4.9 November 1, 2008 OpenBSD 4.9