sdpadm(1M) System Administration Commands sdpadm(1M)NAMEsdpadm - SDP system configuration administration
SYNOPSIS
/usr/sbin/sdpadm status | enable | disable
DESCRIPTION
The sdpadm command is used to display the system state of the Sockets
Direct Protocol (SDP) protocol. The sdpadm command can optionally be
used to set the state of the SDP protocol. See sdp(7D).
By default the SDP protocol is disabled on the system. It can be
enabled by using sdpadm enable.
OPTIONS
The following subcommands are supported:
status Displays the system status of the SDP protocol
enable Enables the SDP protocol
disable Disables the SDP protocol
USAGE
The required privileges to change the state of the SDP protocol are
controlled by the network configuration policy. If a user does not have
the correct privileges to set the SDP policy, sdpadm returns the cur‐
rent state of SDP without having changed the state.
ATTRIBUTES
See attributes(5) for descriptions of the following attributes:
┌─────────────────────────────┬─────────────────────────────┐
│ ATTRIBUTE TYPE │ ATTRIBUTE VALUE │
├─────────────────────────────┼─────────────────────────────┤
│Availability │SUNWibsdpu │
├─────────────────────────────┼─────────────────────────────┤
│Interface Stability │Uncommitted │
└─────────────────────────────┴─────────────────────────────┘
SEE ALSOattributes(5), sdp(7D)
Infiniband Specification Volume 1 (http://www.infinibandta.org)
SunOS 5.10 22 Dec 2008 sdpadm(1M)