RPC.STATD(8) OpenBSD System Manager's Manual RPC.STATD(8)NAMErpc.statd - host status monitoring daemon
SYNOPSISrpc.statd [-d]
DESCRIPTIONrpc.statd is a daemon which co-operates with rpc.statd daemons on other
hosts to provide a status monitoring service. The daemon accepts
requests from programs running on the local host (typically,
rpc.lockd(8), the NFS file locking daemon) to monitor the status of
specified hosts. If a monitored host crashes and restarts, the remote
daemon will notify the local daemon, which in turn will notify the local
program(s) which requested the monitoring service. Conversely if this
host crashes and restarts when rpc.statd restarts, it will notify all of
the hosts which were being monitored at the time of the crash.
The options available are:
-d Causes debugging information to be written to syslog(3),
recording all RPC transactions to the daemon. These messages are
logged with level LOG_DEBUG and facility LOG_DAEMON. Error
conditions are logged irrespective of this option, using level
LOG_ERR.
The rpc.statd daemon must NOT be invoked by inetd(8) because the protocol
assumes that the daemon will run from system start time. Instead, it
should be configured in rc.conf(8) to run at system startup.
FILES
/usr/include/rpcsvc/sm_inter.x RPC protocol specification used by local
applications to register monitoring
requests.
/var/db/statd.status Non-volatile record of currently
monitored hosts.
SEE ALSOsyslog(3), rc.conf(8), rpc.lockd(8)STANDARDS
This implementation is based on the specification in the X/Open CAE
Specification C218, "Protocols for X/Open PC Interworking: XNFS, Issue
4", ISBN 1 872630 66 9.
HISTORY
A version of rpc.statd appeared in SunOS 4.
BUGS
There is no means for the daemon to tell when a monitored host has
disappeared permanently (e.g. catastrophic hardware failure), as opposed
to transient failure of the host or an intermediate router. At present,
it will retry notification attempts at frequent intervals for 10 minutes,
then hourly, and finally gives up after 24 hours.
The protocol requires that symmetric monitor requests are made to both
the local and remote daemon in order to establish a monitored
relationship. This is convenient for the NFS locking protocol, but
probably reduces the usefulness of the monitoring system for other
applications.
The current implementation uses more than 1Kbyte per monitored host in
the status file (and also in VM). This may be inefficient for NFS
servers with large numbers of clients.
OpenBSD 4.9 June 15, 2008 OpenBSD 4.9