ROUTE(7P)ROUTE(7P)NAMEroute - kernel packet forwarding database
SYNOPSIS
#include <sys/socket.h>
#include <net/if.h>
#include <net/route.h>
int socket(PF_ROUTE, SOCK_RAW, family);
DESCRIPTION
The system provides some packet routing facilities. The kernel maintains
a routing information database, which is used in selecting the
appropriate network interface when transmitting packets.
A user process (or possibly multiple co-operating processes) maintains
this database by sending messages over a special kind of socket. This
supplants fixed size ioctl(2)'s used in earlier releases. Routing table
changes may only be carried out by the super user.
The operating system may spontaneously emit routing messages in response
to external events, such as receipt of a re-direct, or failure to locate
a suitable route for a request. The message types are described in
greater detail below.
Routing database entries come in two flavors: for a specific host, or for
all hosts on a generic subnetwork (as specified by a bit mask and value
under the mask. The effect of wildcard or default route may be achieved
by using a mask of all zeros, and there may be hierarchical routes.
When the system is booted and addresses are assigned to the network
interfaces, each protocol family installs a routing table entry for each
interface when it is ready for traffic. Normally the protocol specifies
the route through each interface as a ``direct'' connection to the
destination host or network. If the route is direct, the transport layer
of a protocol family usually requests the packet be sent to the same host
specified in the packet. Otherwise, the interface is requested to
address the packet to the gateway listed in the routing entry ( i.e. the
packet is forwarded).
When routing a packet, the kernel will attempt to find the most specific
route matching the destination. (If there are two different mask and
value-under-the-mask pairs that match, the more specific is the one with
more bits in the mask. A route to a host is regarded as being supplied
with a mask of as many ones as there are bits in the destination). If no
entry is found, the destination is declared to be unreachable, and a
routing-miss message is generated if there are any listers on the routing
control socket described below.
A wildcard routing entry is specified with a zero destination address
value, and a mask of all zeroes. Wildcard routes will be used when the
system fails to find other routes matching the destination. The
combination of wildcard routes and routing redirects can provide an
Page 1
ROUTE(7P)ROUTE(7P)
economical mechanism for routing traffic.
One opens the channel for passing routing control messages by using the
socket call shown in the synopsis above:
The family parameter may be AF_UNSPEC which will provide routing
information for all address families, or can be restricted to a specific
address family by specifying which one is desired. There can be more
than one routing socket open per system.
Messages are formed by a header followed by a small number of sockaddrs
interpreted by position. An example of a message with three addresses
might be a redirect: Destination, Gateway, and Author of the redirect.
The interpretation of which addresses are present is given by a bit mask
within the header, and the sequence is least significant to most
significant bit within the vector.
Any messages sent to the kernel are returned, and copies are sent to all
interested listeners. The kernel will provide the process id. for the
sender, and the sender may use an additional sequence field to
distinguish between outstanding messages. However, message replies may
be lost when kernel buffers are exhausted.
The kernel may reject certain messages, and will indicate this by filling
in the rtm_errno field. The routing code returns EEXIST if requested to
duplicate an existing entry, ESRCH if requested to delete a non-existent
entry, or ENOBUFS if insufficient resources were available to install a
new route. In the current implementation, all routing processes run
locally, and the values for rtm_errno are available through the normal
errno mechanism, even if the routing reply message is lost.
A process may avoid the expense of reading replies to its own messages by
issuing a setsockopt(2) call indicating that the SO_USELOOPBACK option at
the SOL_SOCKET level is to be turned off. A process may ignore all
messages from the routing socket by doing a shutdown(2) system call for
further input.
If a route is in use when it is deleted, the routing entry will be marked
down and removed from the routing table, but the resources associated
with it will not be reclaimed until all references to it are released.
User processes can obtain information about the routing entry to a
specific destination by using a RTM_GET message, or by reading the
/dev/kmem device.
Messages include:
#define RTM_ADD 0x1 /* Add Route */
#define RTM_DELETE 0x2 /* Delete Route */
#define RTM_CHANGE 0x3 /* Change Metrics, Flags, or Gateway */
#define RTM_GET 0x4 /* Report Information */
#define RTM_LOOSING 0x5 /* Kernel Suspects Partitioning */
#define RTM_REDIRECT 0x6 /* Told to use different route */
Page 2
ROUTE(7P)ROUTE(7P)
#define RTM_MISS 0x7 /* Lookup failed on this address */
#define RTM_RESOLVE 0xb /* request to resolve dst to LL addr */
A message header consists of:
struct rt_msghdr {
u_short rmt_msglen; /* to skip over non-understood messages */
u_char rtm_version; /* future binary compatibility */
u_char rtm_type; /* message type */
u_short rmt_index; /* index for associated ifp */
pid_t rmt_pid; /* identify sender */
__uint32_t rtm_addrs; /* bitmask identifying sockaddrs in msg */
int rtm_seq; /* for sender to identify action */
int rtm_errno; /* why failed */
int rtm_flags; /* flags, incl kern & message, e.g. DONE */
int rtm_use; /* from rtentry */
u_long rtm_inits; /* which values we are initializing */
struct rt_metrics rtm_rmx; /* metrics themselves */
};
where
struct rt_metrics {
u_long rmx_locks; /* Kernel must leave these values alone */
u_long rmx_mtu; /* MTU for this path */
u_long rmx_hopcount; /* max hops expected */
u_long rmx_expire; /* lifetime for route, e.g. redirect */
u_long rmx_recvpipe; /* inbound delay-bandwidth product */
u_long rmx_sendpipe; /* outbound delay-bandwidth product */
u_long rmx_ssthresh; /* outbound gateway buffer limit */
u_long rmx_rtt; /* estimated round trip time */
u_long rmx_rttvar; /* estimated rtt variance */
};
Flags include the values:
#define RTF_UP 0x1 /* route usable */
#define RTF_GATEWAY 0x2 /* destination is a gateway */
#define RTF_HOST 0x4 /* host entry (net otherwise) */
#define RTF_REJECT 0x8 /* host or net unreachable */
#define RTF_DYNAMIC 0x10 /* created dynamically (by redirect) */
#define RTF_MODIFIED 0x20 /* modified dynamically (by redirect) */
#define RTF_DONE 0x40 /* message confirmed */
#define RTF_MASK 0x80 /* subnet mask present */
#define RTF_CLONING 0x100 /* generate new routes on use */
#define RTF_XRESOLVE 0x200 /* external daemon resolves name */
#define RTF_LLINFO 0x400 /* generated by ARP or ESIS */
#define RTF_STATIC 0x800 /* manually added */
#define RTF_BLACKHOLE 0x1000 /* just discard pkts (during updates) */
Page 3
ROUTE(7P)ROUTE(7P)
#define RTF_PROTO2 0x4000 /* protocol specific routing flag #1 */
#define RTF_PROTO1 0x8000 /* protocol specific routing flag #2 */
#define RTF_CKSUM 0x10000 /* TCP/UDP checksumming done on this route */
Specifiers for metric values in rmx_locks and rtm_inits are:
#define RTV_SSTHRESH 0x1 /* init or lock _ssthresh */
#define RTV_RPIPE 0x2 /* init or lock _recvpipe */
#define RTV_SPIPE 0x4 /* init or lock _sendpipe */
#define RTV_HOPCOUNT 0x8 /* init or lock _hopcount */
#define RTV_RTT 0x10 /* init or lock _rtt */
#define RTV_RTTVAR 0x20 /* init or lock _rttvar */
#define RTV_MTU 0x40 /* init or lock _mtu */
Specifiers for which addresses are present in the messages are:
#define RTA_DST 0x1 /* destination sockaddr present */
#define RTA_GATEWAY 0x2 /* gateway sockaddr present */
#define RTA_NETMASK 0x4 /* netmask sockaddr present */
#define RTA_GENMASK 0x8 /* cloning mask sockaddr present */
#define RTA_IFP 0x10 /* interface name sockaddr present */
#define RTA_IFA 0x20 /* interface addr sockaddr present */
#define RTA_AUTHOR 0x40 /* sockaddr for author of redirect */
SEE ALSOip(7p), netintro(7p)
Page 4
