gfxtopology(1G)gfxtopology(1G)NAMEgfxtopology - graphics topology information
SYNOPSIS
/usr/gfx/gfxtopology
DESCRIPTION
The gfxtopology command extracts information about the graphics pipes,
keyboards, and mice attached to the system from the hardware graph and
/etc/ioconfig.conf. This information is then displayed to relate the
physical location of the devices to the logical configuration from
ioconfig.conf.
The first section of the gfxtopology output describes the brick that the
G brick is attached to, as well as the information for the GE board of
that pipe.
The second section describes the physical location of the mouse and
keyboard corresponding to the listed /hw/input directory.
EXAMPLE
The following output from gfxtopology that has 6 pipes attached, and has
8 keyboards and 5 mice attached.
# /usr/gfx/gfxtopology
pipe 0 g @ 001c07/I:11 GE14-4 030-1129-002 A DDR438
pipe 1 g @ 001c10/X:10 GE16-4 030-1398-001 E KDK504
pipe 2 g @ 011c07/I:10 GE16-4 030-1398-001 E KGF788
pipe 3 g @ 011c10/I:10 GE16-4 030-1398-001 E KCJ540
pipe 4 g @ 011c13/I:10 GE14-4 030-1129-002 K FSY253
pipe 5 g @ 011c16/I:10 GE16-4 030-1398-001 E KWH011
input k @ 001c07/I:1/1 m @ 001c07/I:1/2
input1 k @ 011c07/I:1/1 * m @ 011c07/I:1/1 *
input2 k @ 011c07/I:1/3 m @ 011c07/I:1/4
input3 k @ 011c07/I:2/1 m @ 011c07/I:2/1
input4 k @ 011c07/I:2/3 m @ 011c10/I:1/1
input5 k @ 011c07/I:2/4
input6 k @ 011c10/I:1/1
input7 k @ 011c10/I:1/3
* - missing device
HARDWARE
This command only works on Onyx2 and Onyx3000 series machines with
InfiniteReality graphics pipes.
SEE ALSOhwgraph(4), ioconfig(1M)
Page 1
