evmreload(1M)evmreload(1M)NAMEevmreload - reload Event Manager configuration files
SYNOPSISDESCRIPTION
The command posts control events that instruct EVM resident components
to reload their configuration files. Use the command to cause EVM to
begin using the new configuration at any time that a configuration file
has been changed.
If no options are specified, the daemon, the channel manager, and the
logger all reload their configurations.
Reconfigure the daemon at any time that its configuration file or that
an event template database has changed. Reconfigure the logger at any
time that its configuration file has changed. Reconfigure the channel
manager at any time that its configuration file has changed.
Resident EVM components also reload their configuration files on
receipt of a signal.
If an activity monitor is specified in the EVM daemon configuration
file, all counts and timers associated with the monitor are reset.
Options
Reconfigures the EVM channel manager.
Reconfigures the EVM daemon.
Reconfigures the EVM logger.
Syntax checks the event template files and reports errors, but does not
make any changes effective.
If a daemon reconfiguration is requested, the reconfiguration request
is sent even if there are errors in any template file. If
errors exist in the template file, there is no guarantee that
the new configuration is accepted.
Notes
The command uses the command to check for errors in configuration files
before sending a reload request to EVM. If errors are found, they are
reported to and no reconfiguration request is sent. This check does
not find all possible errors, however, so be sure to check for errors
reported by the EVM components themselves. To do this, run the follow‐
ing command:
RETURN VALUES
The following exit values are returned:
Successful completion.
An error occurred.
EXAMPLES
· The following command causes the EVM daemon to reconfigure itself.
· The following command causes the EVM logger to reconfigure itself.
· The following command causes the EVM channel manager to reconfigure
itself.
· The following command causes a syntax check of the daemon configura‐
tion file without any reconfiguration actually occurring.
· The following command reconfigures both the EVM daemon and the EVM
logger.
· The following command reconfigures the EVM daemon, the EVM logger,
and the EVM channel manager.
· The following command reconfigures the EVM daemon, the EVM logger,
and the EVM channel manager even if there are errors in the template
file.
WARNINGS
You must be to run this command.
SEE ALSO
Commands
evmpost(1), evmchmgr(1M), evmd(1M), evminfo(1), evmlogger(1M).
Files
evmchannel.conf(4), evmdaemon.conf(4), evmlogger.conf(4).
Event Management
EVM(5).
EVM Events
EvmEvent(5).
evmreload(1M)